The Moon will located on the same side of the Earth as the Sun and will not be visible in the night sky. Since hunting is difficult, this moon has also been known by some tribes as the Hunger Moon, since the harsh weather made hunting difficult. This full moon was known by early Native American tribes as the Snow Moon because the heaviest snows usually fell during this time of the year. The Moon will be located on the opposite side of the Earth as the Sun and its face will be will be fully illuminated. This is the best time of the month to observe faint objects such as galaxies and star clusters because there is no moonlight to interfere.įebruary 24 - Full Moon. This moon has also been know as the Old Moon and the Moon After Yule.įebruary 9 - New Moon. This full moon was known by early Native American tribes as the Wolf Moon because this was the time of year when hungry wolf packs howled outside their camps. Look for the planet low in the eastern sky just before sunrise. This is the best time to view Mercury since it will be at its highest point above the horizon in the morning sky. The planet Mercury reaches greatest western elongation of 23.5 degrees from the Sun. January 12 - Mercury at Greatest Western Elongation. This is the best time of the month to observe faint objects such as galaxies and star clusters because there is no moonlight to interfere.

Meteors will radiate from the constellation Bootes, but can appear anywhere in the sky. Best viewing will be from a dark location after midnight. The waning gibbous moon will block out some of the fainter meteors, but if you are patient this could still be a good show. It peaks this year on the night of the 3rd and morning of the 4th. The shower runs annually from January 1-5. It is thought to be produced by dust grains left behind by an extinct comet known as 2003 EH1, which was discovered in 2003. The Quadrantids is an above average shower, with up to 40 meteors per hour at its peak. were glued and/or screwed into place.January 3, 4 - Quadrantids Meteor Shower. To finish it all up, all of the many scale details in the form of antennas and foot braces, etc. There are two plastic quick releases that hold the wing in place with make it an easy prospect to take the wings on and off. Next, the slats were glued to the wing leading edges with medium CA and then placed onto the fuselage over the carbon spar. Once in, then the tail braces are clipped into place as well. It's important here that the tail be pressed fully forward with a notable click in place to ensure it is fully locked in place. From there, the horizontal tail is slid into place. From there, the tail wheel is fastened into place via 2 screws and 2 lock nuts and is shock absorbing as well. Assembly starts with installation of the shock absorbing landing gear via 4 screws which have plastic fairings over a carbon strut and feature the dual shocks of the full size.

The E-flite DRACO 2.0m is an impressively large airplane that is been broken down into only just a few large components which means that despite the large size, assembly is quick and easy.

Horizon hobbies draco